Support:Documents:Manual:COMKAT utilities
Diagnostic functions
Validation suite
The validation suite is aimed for users to validate a new COMKAT installation. It generates model output calculated by COMKAT and analytic solution. The user may then compare output from his/her computer and the developer's computer. The difference should be very little if not any if the installation is correct.
To run validation, run command 'validate' under Matlab. A window should pop up as:
Click on the model that you would like to compare your results to the developer's. Then wait without doing anything. (If you click on any of the figure during execution the display of results might be wrong.) Wait until a report is generated in your browser. Go to the results section and compare the figures of results from your computer and the developer's.