Support:Documents:Manual:COMKAT Input Function

The input function toolbox starts with whole blood activity page. To see which page you are currently on look at the section of Steps which is present on the lower left hand side corner of the toolbox, where the current active page is highlighted. The toolbox starts by first defining the Whole blood acitivty followed by Metabolites (Ligand in plasma fraction) and then finally the Result verification page. The following paragraphs define the possible usage and the implementation of each of the above mentioned sections in detail.

1. Whole blood activity

To define the whole blood activity make sure the section of Steps which is present on the lower left hand side corner of the toolbox has the text Whole blood activity highlighted (by default the toolbox starts from the whole blood activity page), if not use the arrow keys to get to the whole blood activity page. The input function represents the arterial whole blood activity measured during the course of an experiment. Whole blood activity can be defined either using a simlation tool or by using an experimental data file. Simulation tool uses functions like feng input and gamma3 to simulate the whole blood activity whereas experimental data file shows the activity measured using a blood activity monitor (BAM) or manual samples.

Let us first define the whole blood activity using the simulation tool for which we use the section named Input function.

Simulation

A) Types of functions: Feng Input, Gamma3, User defined spline

The input function represents the arterial whole blood activity measured during the course of an experiment. Whole blood activity can be defined either using a simlation tool or by using an experimental data file. In this section we define the whole blood activity using the simulation tool, for this we use the section named Input function. We start by first selecting the type of function which could either be Feng input, Gamma3 or a User defined spline.

Feng Input

Whole blood activity is simulated using the feng input model which is given by the following equation

Gamma3

Whole blood activity is simulated using the gamma3 model which is given by the following equation

User define spline

User defined spline can be used in two ways

1. Load an input function defined in a piecewise polynomial form
   If the user has a variable defined in a piecewise polynomial (ppval) form (example: if the user uses commands like "SPLINE" or "LSPLINE" then this creates a variable with a ppval form) and if it contains necessary information about whole blood activity then this feature of User defined spline can be used to load that data into COMKAT. It is however important to note that the user should create the variable having the ppval form before he selects the feature of user defined spline, and also the variable should be created in the command window of Matlab (Note: The workspace should have its stack with the option "Base" selected while creating the variable in command window). A variable with a ppval form can be created in the command window of Matlab by typing the following commands:
   
   x = 0:8;
   y = [0 .15 1.12 2.36 2.36 1.46 .49 .06 0];
   cs = spline(x,[0 y 0]);
   This creates a variable by the name "cs" in the command window which has a ppval form
   
   ppnew=spline(0:.1:100,sin(0:.1:100));
   
   Similary the above command creates a variable by the name "ppnew" in the command window having a ppval form. Also note that the input function in COMKAT assumes that the default units for concentration are "micro-curie/ml" and that of time are "minutes", hence while creating an input function do create in terms of these default units.When the user selects the feature of user defined spline, the following pop up window appears